Formax Cut-True 27A - Manual (Page 13)

10
Adjustment of Cut
If you set the initial cut at 18” but only insert paper that is
17”, you need to enter 17” in this space indicated (Fig. 13)
and press the calibrate back gauge icon to confirm the
adjustment.
Fig. 13
Enter number here
Back gauge
calibration icon
OILING
All moving parts with screws should be checked periodically to be sure the screws are tight. They may become loose in
the process of transportation. Users should also check and tighten the screws after more than 200 cutting cycles.
All moving parts should be lubricated and oiled periodically to maintain performance and equipment life. Before lubricat-
ing, these parts should be cleaned to remove paper dust and old deposits of oil and grease.
Press the Tool Box icon, then the lubrication icon and follow the steps outlined on the screen.