Formax Cut-True 27A - Manual (Page 17)

Resetting the Blade Change Notification Message
Step 1: Press
“HOME” to move the
backgauge to the
start position before
resetting the counter.
Step 2:
Select the blade
change icon, shown
here.
Step 3:
The number on the
screen will show
1500.
Step 4:
Press the number on
the screen until the it
reads “Do you want to
delete it?”
When the Cut-True 27A has reached 1,500 cuts, a message will appear on the control panel “CUT1500.” When this
happens, check the blade to see if it is dull or still sharp enough to cut through one sheet of copy paper. If it is dull, replace
the blade using the procedure on the following pages.
If the blade is still sharp, reset the control panel message using these steps:
Step 5:
Select “SAVE” to
reset the counter to
zero
Counter is reset to
zero.
This message will
appear on the screen.
14