GAI-Tronics 238-002 Stainless Steel Surface-mount Call Box Enclosure User Manual
Confidentiality notice, General information, Installation
Pub. 42004-496A
GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA
610-777-1374
800-492-1212 Fax: 610-796-5954
V
ISIT WWW
.
GAI
-
TRONICS
.
COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Model 238-002 Stainless Steel
Surface-Mount Call Box Enclosure
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information which is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
The Model 238-002 Stainless Steel Surface-Mount Call Box Enclosure is designed to house a GAI-
Tronics CB195 series Flush-mount RF Call Box. The following components are supplied with the Model
238-002 Enclosure:
Qty Description
2 Conduit
seals
2 Hole
gaskets
8
#6-32 keps nuts
2
#8-32 keps nuts
4 Rubber
washers
Installation
Safety Guidelines
Please refer to the guidelines presented in the RF call box manual, Pub. 43004-031, to ensure the safety
of all personnel when installing GAI-Tronics’ call box equipment.
Mounting
NOTE
GAI-Tronics flush-mount call boxes are equipped with a metal back box that is not
required and should be removed prior to installing the call box in the 238-002 Enclosure.
1. Cables can enter the enclosure through the access holes in either the back or bottom of the unit. Hole
caps are provided to seal the holes that are not used. The Model 238-002 is provided with two hole
caps installed in the bottom of the enclosure. If the entry is from the back of the unit, install two
gaskets (provided) to seal around the holes. If conduit entrance is desired into the bottom of the unit,
remove the hole caps from the bottom two holes and install them in the two holes located on the back
of the enclosure.