GAI-Tronics 69255-001 Page/Party Interface PCBA - Manual (Page 5)

Pub. 42004-608L2B
69255-001 Page/Party
®
Interface PCBA Page: 5 of 10
f:\standard ioms - current release\42004 instr. manuals\42004-608l2b.doc
11/10
Installation/Replacement
WARNING: Failure to observe warnings may result in equipment damage.
WARNING: Observe
Precautions For
Handling Electrostatic
Sensitive Devices
1. Remove the 69255-001 PPI from its carton. Be sure to check that power is disconnected to the card
rack assembly prior to replacement.
2. Set hardware jumpers per the system manual and as described below. See Figure 1 for details.
Address/PCBA ID:
• Hex switch (S1) and jumper W1 set the PCBA address
• Jumper J7 sets extended PCBA ID
• Hex switch (S2) sets the PCBA ID number
• For PPIs 1-14, short pins 2 and 3 of jumper J7.
• For PPIs 15 and 16, short pins 1 and 2 of jumper J7.
• Valid PCBA ID’s are: 01-0E, and 11-12[hex]
PCBA ID Example:
PCBA ID 0 A (hex)
/ /
Equals 0 when J7 pins 2 and 3 are shorted ----/ / Set by switch S2
Equals 1 when J7 pins 1 and 2 are shorted ----/
• Valid PCBA addresses are: 0x0200-0x03F0 [hex]
Address Example:
Address 2 E 0 (hex)
/ / Fixed
/ / Set by switch S1
Equals 2 when W1 is installed ------/
Equals 3 when W1 is removed-------/
WARNING:
Disconnect Power To
The Card Rack Prior
To Installation