GAI-Tronics 701-302ICS ICS AC-Powered Page/Party Plug-in Amplifiers - Manual

Pub. 42004-730L2BQG
GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
ICS AC-Powered Page/Party ® Plug-in Amplifiers - Quick Installation Guide
Important Safety Instructions
This equipment is suitable for use in Class I, Division 2, Groups A, B, C and D, Class II Division 2, Groups F, and G, Class III OR non-hazardous locations only.
Combinations of equipment in your system are subject to investigation by the local Authority Having Jurisdiction at the time of installation.
Read, follow, and retain instructions – All safety and operating instructions should be read and followed before operating the unit. Retain instructions for future
reference.
Heed warnings – Adhere to all warnings on the unit and in the operating instructions.
Attachments – Attachments not recommended by the product manufacturer should not be used, as they may cause hazards. Maximum system cable length is not to
exceed two miles.
Servicing – Do not attempt to service this unit by yourself. Opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to
qualified service personnel.
This permanently connected apparatus must have a UL Listed 15-amp circuit breaker incorporated in the electrical installation of the building.
WARNING – EXPLOSION HAZARD – Do not disconnect equipment unless power has been removed or the area is known to be non-hazardous. Averttissement –
Risque d’explosion – avant de déconnector l’equipment, couper le courant ou s’assurer que l’emplacement est désigné non dandereux.
USA and Canada Consult the National Electrical Code (NFPA 70), Canadian Standards Association (CSA 22.1), and local codes for specific requirements regarding
your installation. Class 2 circuit wiring must be performed in accordance with NEC 725.55.
General Information and Available Options
This quick guide covers the installation of the ICS AC-Powered Plug-in Amplifiers. See the chart below for applicable models.
ICS Amplifier
Model
Description
751-001ICS Speaker Amplifier
701-302ICS Handset/Speaker Amplifier
701-304ICS Handset/Speaker Amplifier with
Auxiliary Jack
751-001ICSVC Speaker Amplifier with VLC
701-302ICSVC Handset/Speaker Amplifier with
VLC
701-304ICSVC Handset/Speaker Amplifier with
Auxiliary Jack and VLC
751-901ICS SmartSeries Speaker Amplifier
701-902ICS SmartSeries Handset/Speaker
Amplifier
701-904ICS SmartSeries Handset/Speaker
Amplifier with Auxiliary Jack
Figure 1. ICS AC-Powered Page/Party ® Plug-in Amplifier Installation
Refer to Pub. 42004-730L2 at the “Manuals & Specs” link at
www.gai-tronics.com for detailed explanations of the available models
and their settings, adjustments and warranty.
Installing the ICS Page/Party ® Plug-in Amplifier
1. Plug the amplifier directly into the enclosure. Use extra care not to damage the protruding latch wings of connector P6 located on
the top right edge of the amplifier during installation.
2. Attach the amplifier to the enclosure with the hardware provided. See Figure 1.
3. Apply power to the station.