GAI-Tronics 701-302ICS ICS AC-Powered Page/Party Plug-in Amplifiers User Manual
Page 2
Pub. 42004-730L2BQG
ICS AC-Powered Page/Party
®
Plug-in Amplifiers Quick Installation Guide
Page: 2 of 2
f:\standard ioms - current release\42004-xxxxqg quick guides\42004-730l2bqg.doc
04/11
Enclosure RTU Connection (if applicable)
Amplifiers with VLC or SmartSeries PCBAs can be connected via an enclosure ribbon cable to provide a double-pole, Form “C” relay
and one fuse-protected contact. If an RTU is present in the enclosure, connect the ribbon cable provided to the receptacle on the top
side of the amplifier.
Available Adjustments
Most models are preconfigured to a default standard at the factory. The following is a partial list of the available adjustments and
settings that may be needed. Refer to Pub. 42004-730L2 for complete information.
Standard AC-Powered
ICS Plug-in Amp
ICS Plug-in Amp with VLC
SmartSeries AC-Powered Plug-
in Amp
•
Speaker Volume
•
Speaker Volume
•
Address
•
Speaker Mute
•
Speaker Mute
•
ALS Minimum Level
•
Speaker Gain
•
Speaker Gain
•
ALS Offset Level
•
Transmit Level
•
Transmit Level
•
SmartSeries VLC Level
•
Receiver Volume
•
Receiver Volume
•
FSK Signal Gain
•
Audio Alignment
•
Page Disable Control
•
Remote Signaling (RTU)
NRTL Listed for USA and Canada..................................................................................
Class I, Groups A, B, C, and D, Division 2;
Class II, Groups F and G, Division 2;
Class III, Division 2 Hazardous Locations
Temperature code, T4