GAI-Tronics 12536-001, 12536-002 Trim Frame Kit - Manual

Pub. 42003-054B
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Single-Party and Multi-Party Trim Frame
Replacement Kits
Models 12536-001 and 12536-002
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
The Model 12536-001 and 12536-002 Single-Party and Multi-Party Trim Frame Replacement Kits are
used on any 600 or 700 Series single or multi-party indoor wall station to allow flush-mounting of the
unit. When the units are flush-mounted, the cable should still be installed through conduit, because the
Page/Party
® cable outer layer is not rated to be installed without conduit protection. These kits include
the following components:
Qty Description
1 Frame
4 Washer
1
Party-line Label (Model 12536-002 only)
Installation
Single-Party Trim Frame Kit (Model 12536-001)
1. If the wall station is already installed: Loosen the four front panel screws, and remove the handset
station from the amplifier. Remove the four screws securing the amplifier to the wall.
2. You will need to install the washers under the blue connector assembly. On the rear surface of the
enclosure, locate the blue connector mounted on two standoffs.
3. Remove the two screws securing the connector to these standoffs.
4. Place the washers (two on each side) between the connector and the standoffs.
5. Reinstall the screws to secure the blue connector.