GAI-Tronics 12536-001, 12536-002 Trim Frame Kit - Manual (Page 2)

Pub. 42003-054B
M ODEL 12536-001 AND 12536-002 S INGLE AND M ULTI -P ARTY T RIM F RAME K ITS Page: 2 of 3
\\s_eng\gtcproddocs\standard ioms - current release\42003 kit manuals\42003-054b.doc
5/95
6. Cut a hole in the wall that measures approximately 1 / 8
-inch larger than the enclosure on all sides.
7. Mount the enclosure in the hole.
8. The trim frame is secured to the enclosure by the amplifier.
9. Place the handset amplifier through the trim frame and into the enclosure, making sure all the
mounting holes are properly aligned.
10. Tighten the four corner screws to mount the unit.
Multi-Party Trim Frame Kit (Model 12536-002)
1. If the wall station is already installed: Turn off the power to the station. Loosen the eight front panel
screws, and remove the handset station and the top panel from the enclosure. Remove the four screws
securing the amplifier to the wall.
2. You will need to install the washers under the blue connector assembly. On the rear surface of the
enclosure, locate the blue connector mounted on four standoffs.
3. Remove the four screws securing the connector to the standoffs.
4. Place the washers between the connector and the standoffs.
5. Reinstall the screws to secure the blue connector to the mounting blocks.
6. Set the party-line selector switch to party line 1. Using a 1 / 16
-inch (#21) Allen wrench, loosen the two
set screws in the selector knob. One screw is to the right of the party-line indicator; the other screw is
in the end of the knob. After loosening the screws, lift the knob off, and set it and the screws aside.
Note the position of the flat on the switch with respect to the small hole in the panel where the anti-
rotation tab fits and position 1 on the party-line label. The new party-line label must be installed on
the trim frame in the same orientation.
7. Remove and retain the four screws that secure the 4
× 8-inch switch plate to the upper part of the
enclosure.
8. Remove and retain the nut ( 7 / 16
-inch) and lockwasher that hold the rotary switch to the switch plate.
Note the position of any washers or switch lock tabs.
9. Remove and discard the 4
× 8-inch panel.
10. Remount the party-line switch on the trim frame using the 7 / 16
-inch nut and lock washer.
11. Orient the switch so that the locking tab inserts into the hole in the trim frame to prevent the switch
from turning in its mounting hole.
12. Loosely mount the trim frame to the enclosure using the four screw holes at the top of the trim frame.