GAI-Tronics 12565-001 Replacement Kit for 69701-101 (701-10x to 701-20x) User Manual
Page 3
Pub. 42003-079C
M
ODEL
12565-001
P
RINTED
C
IRCUIT
B
OARD
A
SSEMBLY
R
EPLACEMENT
K
IT
Page:
3 of 3
\\s_eng\gtcproddocs\standard ioms - current release\42003 kit manuals\42003-079c.doc
2/97
Installing the New Receiver
1. Position the receiver with the varistor facing down.
2. Remove the two screws in the receiver.
3. Place the board on the receiver with the antenna pointing up, away from the varistor.
4. Screw the board to the receiver with the green wire under the left screw where indicated.
5. Attach the red wire to the standoff in the center of the board.
6. Bend the antenna so that it is flat against the side of the receiver. Then bend the small end around the
corner so it is tight against the front of the receiver.
7. Place the receiver assembly in the handset.
8. Tighten the receiver cap.