GAI-Tronics 12531-001 Wire Harness Replacement Kit for Models 13350, 13351 - Manual

Pub. 42003-087
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Wire Harness Replacement Kit
Model 12531-001
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
The Model 12531-001 Wire Harness Replacement Kit is designed for the GAI-Tronics Models 13350 and
13351. This kit includes the following components:
Qty Description
1 Quick-connect receptacle/connector harness assembly, 4-wire (for use with Model 13350 only)
1 Harness assembly with quick-connect receptacles, 2-wire (for use with Model 13351 only)
Installation
In the Model 13350 Only
1. Loosen the six front panel captive screws.
2. Gently pull the front panel of the speaker away from the rear enclosure. Disconnect the two quick-
connect receptacles from the rear enclosure terminal block.
3. Lay the speaker front panel on a flat surface. Remove the two quick-connect receptacles from the
speaker. Discard the old harness assembly.
4. Install the new harness assembly by connecting the black wire receptacle to the speaker terminal with
the red mark. Connect the white wire receptacle to the other speaker terminal.
5. Connect the wires to the rear enclosure terminal block terminals, following the wiring guidelines on
the terminal block label.
6. Align the speaker front panel with the rear enclosure. Tighten the front panel screws to 16–20 in-lbs.
torque.