GAI-Tronics 12531-001 Wire Harness Replacement Kit for Models 13350, 13351 User Manual
Page 2
Pub. 42003-087
M
ODEL
12531-001
W
IRE
H
ARNESS
R
EPLACEMENT
K
IT
Page:
2 of 2
\\s_eng\gtcproddocs\standard ioms - current release\42003 kit manuals\42003-087.doc
1997
In the Model 13351 Only
1. Loosen the six front panel captive screws.
2. Gently pull the front panel of the speaker away from the rear enclosure. Unplug the wire harness
connector located below the speaker.
3. Lay the speaker front panel on a flat surface. Remove the quick-connect receptacle from the rear
enclosure terminal block. Discard the old harness assembly.
4. Install the new harness assembly by connecting the quick-connect terminals to the rear enclosure
terminal block terminals matching the terminal block label designations as follows: black: COM;
yellow: 3.7 W; orange: 7.5 W; red: 15 W.
5. Plug the wire harness connector into the connector located below the speaker.
6. Align the speaker front panel with the rear enclosure. Tighten the front panel screws to 16–20 in-lbs.
torque.