GAI-Tronics 12552-001 Rotary Switch Harness Assembly User Manual

Rotary switch harness assembly replacement kit, Confidentiality notice, General information

Advertising
background image

Pub. 42003-122A

GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA

610-777-1374

„ 800-492-1212 „ Fax: 610-796-5954

V

ISIT WWW

.

GAI

-

TRONICS

.

COM FOR PRODUCT LITERATURE AND MANUALS

G A I - T R O N I C S ® C O R P O R A T I O N

A H U B B E L L C O M P A N Y

Rotary Switch Harness Assembly

Replacement Kit

M

ODEL

61504-053

Confidentiality Notice

This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information which is confidential and proprietary to GAI-Tronics. GAI-
Tronics retains all intellectual property and other rights in or to the information contained herein, and such
information may only be used in connection with the operation of your GAI-Tronics product or system.
This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any third party.

General Information

The Model 61504-053 Rotary Switch Harness Assembly Replacement Kit is intended for use on the
Model 478-002 Centra-Page II/Electro-Sound II (CPII/ESII) Desktop Subset.

Installation

Removing the Old Harness Assembly

1. Locate the party-line selector switch on the front panel of the subset. Use flat blade screwdriver to

pop out the cap in the center of the knob.

2. Using long-nosed pliers or a wrench, loosen, but do not remove, the hex nut inside the party-line

selector knob.

3. Remove the party-line selector knob.

4. Use the long-nose pliers or a wrench to remove and discard the collar nut securing the party-line

selector switch to the front panel.

5. Remove and save the four screws securing the housing to the bottom panel.

6. Hinge the housing forward to access the interior of the telephone. Locate the post header on the

printed circuit board marked

J3

,

PARTY LINE SELECT

. Disengage the connector from this post

header.

7. Pull the party-line selector switch through the rear of the front panel, and discard the old harness

assembly.

8. Remove and discard the two-party line label.

Advertising
This manual is related to the following products: