GAI-Tronics 12607-002 Party-Line Selector Knob Replacement Kit - Manual

Pub. 42003-174
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Party-Line Selector Knob Replacement Kit
M
ODEL
12607-002
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains sensitive
business and technical information that is confidential and proprietary to GAI-Tronics. GAI-Tronics retains
all intellectual property and other rights in or to the information contained herein, and such information may
only be used in connection with the operation of your GAI-Tronics product or system. This manual may not
be disclosed in any form, in whole or in part, directly or indirectly, to any third party.
General Information
The Model 12607-002 Replacement Kit is provided to replace the party line selector knob on the
GAI-Tronics Model 7115-102, 7165-102, and 7265-101 Page/Party
® subsets. This kit includes the
following components:
Qty Description
1 Knob
1 Knob Cap
1 Selector Switch Assembly (includes PCBA)
Installation
Model 7115-102 Desk-edge and 7165-102 Flush-Mount Subsets
Refer to Figure 1.
1. Remove the four screws securing the side cover of the Model 7115-102 or the rear cover of the Model
7165-102. Save for re-assembly.
2. Disconnect the ribbon cable from the selector switch assembly PCBA.
3. Pop the cap out of the top of the knob and discard the cap.
4. Remove the nut and the lock washer from the knob and save for re-assembly. Discard the knob.
Note the pointer position when removing and ensure that the pointer on new knob is reinstalled in the
same position.
5. Remove the remaining nut and lock washer and remove the old selector switch assembly. Save the nut
and lock washer for re-assembly.