GAI-Tronics 12520-008 Red Push Button Sealing Boot Kit - Manual

Pub. 42003-215A
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Red Push Button Sealing Boot Kit
Model 12520-008
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
The Model 12520-008 Red Push Button Sealing Boot Kit is intended for use on the Model 290 Series
Emergency Phones to seal the emergency button against moisture.
Installation
1. Open the emergency phone by removing the four tamper-resistant screws in the corners of the front
cover.
2. Loosen the two set screws that hold the red emergency button assembly in place. Unscrew the black
collar containing these screws and pull away the gray retaining ring beneath it. The red emergency
button assembly will pull free from the front cover.
3. Holding the emergency button from the back, pull the sealing boot over the button making sure there
is no folding of the boot edge. Avoid pressing the button with the palm of your hand to ensure that
the button does not develop a vacuum beneath the sealing boot that could prevent switch activation.
4. Test the button after the sealing boot is in place.
! !
Note Ensure that the button still makes the characteristic clicking sound indicating that it is
activating when pressed.
If necessary, allow the vacuum to dissipate by pulling the sealing boot away at the edge, and then
allowing it to regain its shape.