GAI-Tronics 12587-104 ICS Subset-to-ICS Page/Party Amplifier 15-Foot Cable Assembly - Manual

Pub. 42003-233B
GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
ICS Subset to ICS Page/Party ® Amplifier
15-Foot Cable Assembly
M
ODEL
12587-104
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics. GAI-
Tronics retains all intellectual property and other rights in or to the information contained herein, and
such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
The Model 12587-104 ICS Subset to ICS Page/Party ® Amplifier Cable Assembly makes it possible to
connect an ICS Page/Party
®
remote subset to an ICS remote amplifier when the cable assembly must fit
through conduit or a narrow wall cavity when being routed.
The Model 12587-104 Cable Assembly consists of a 15-foot, 24-conductor, PVC jack cable with a DB25
connector on one end and stripped and tinned wires on the other end. This allows the attachment of an
additional DB25 connector after the wire is installed into a receptacle box.
Installation to a Wall Receptacle
1. Arrange the cable so that connector P1 is located at the ICS amplifier enclosure. Plug the DB25
connector into the bottom of the amplifier enclosure and secure the thumb screws from the male
DB25 connector.
Figure 1. Installation