Setup – GAI-Tronics 12577-011 and 12577-018 Access Panel-to-Fiber Interface Kits User Manual
Page 3
Advertising
Pub. 42003-262A
M
ODEL
12577-011
&
12577-018
A
CCESS
P
ANEL
-
TO
-F
IBER
I
NTERFACE
K
ITS
Page
3 of 4
e:\standard ioms - current release\42003 kit manuals\42003-262a.doc
11/13
Setup
1. Ensure both fiber interfaces are installed and powered up. Ensure that the TX connector on the near
interface is connected to the RX connector on the far interface and vise-versa.
2. Transmit levels are set by the GAIN
SELECT jumper on the PCBA. The XMIT and LIMIT LEDs are
used to indicate the optimum setting.
3. Move the GAIN
SELECT jumper to the highest position that will keep the green XMIT LED on, but
will not turn on the orange LIMIT LED.
4. Repeat for both fiber interfaces.
Figure 2. Data Card Connectors and LEDs
Figure 3. Outdoor Housing Mounting Details
Advertising