Gullco GK-200-RLx-I - Manual (Page 9)

7
The following graphical labels are applied to the relevant GSP controls to identify their function:
The following provides a brief description of the GSP controls (refer to the sketch below):
Command Forward Motion
Speed & Parameter Value
Display
Speed Display Calibrated in
Inches per Minute
Speed Display Calibrated in
Centimeters per Minute
Auto Cycle Mode (Constant)
Programming mode (Flashing)
Manual Mode (Absent)
Speed Adjustment
Counter-Clockwise = Slower
Clockwise = Faster
Neutral
Command Reverse Motion
Program Variable Selector Switch
(Extended or Recessed)
Control in Run Mode
Cycle Push Button
(Extended or Recessed)
Arc Signal Active
Hold (Stop) Mode Active
Reverse Motion Commanded
Forward Motion Commanded
Control in Hold (Stop) Mode
CYCLE CONTROL (Master)
Drives the motor Forward
and Reverse repeatedly
between limit switches. Also
commands the Arc Signal
Relay.
INDEX CONTROL (Slave)
Drives the motor a
programmed distance in the
same direction at the end of
each cyclic pass.