Battery replacement – Highgear TerraPod User Manual

Page 9

Advertising
background image

E

N

G

LI

SH

8

ALTImETER / bAROmETER - Notes and Warnings

NOTE: Always use an accurate source when adjusting the Altimeter or Barometer modes.
If you set any of the units incorrectly or extremely far away from the actual readings, all
measurements in this mode will be highly inaccurate.

NOTE: Never adjust the AltImeter/BArometer inside a pressurized environment like
an airplane, air conditioned or heated room.

WARNING: Never adjust the AltImeter/BArometer while you are traveling at high
speeds like inside a moving car or skiing down the mountain. Not only will the measure-
ments be highly inaccurate, hitting a tree can really hurt bad!

NOTE: the weather forecast cannot be active while altitude is displayed on the unit.
You must scroll to a view that does not have altitude to ensure an accurate forecast.

NOTE: If you use the unit on a daily basis in tIme, AltImeter/BArometer mode with
altitude display, you must scroll to a view without altitude to begin the forecasting process.
this process takes 12 hours.

NOTE: Daily use inside a moving car or pressurized room will affect the forecast.
the forecast is designed for extended outdoor use.

How to replace the batteries on your TERRAPOD
If you need to replace the battery, we highly recommend you contact the retailer or our
customer service department.
To replace battery:
1. Use a Phillips screwdriver to unscrew the lid of the
battery compartment.
2. Remove the old battery and insert the new one
matching the polarities.
3. Carefully, remove the plastic battery cover by

turning it counter-clockwise.
Note: Before replacing the lid make the rubber gasket
is seated properly in the molded groove.
4. Replace the lid using a Phillips screwdriver, screw
until firmly in place.

NOTE: When battery is replaced it is important to
re-calibrate the

compass’s magnetic sensor.

NOTE: While the low battery icon is displayed, instant
altitude, maximum altitude, air pressure, sea level
pressure, temperature and compass values show “ - - ” .
It will return to normal once battery has been replaced.

battery Replacement

CR2032

+

+

CR2032

CR2032

+

+

CR2032

Advertising