Hypertherm HRT2 - Manual (Page 28)

Torch seTup
2-14 Duramax Retrofit Torch Operator Manual
Torches without a quick disconnect connector - Powermax600 CE
1. Turn OFF the power switch and remove the power cord from the power receptacle.
2. Disconnect the gas supply hose from the power supply.
Caution: Do not tighten the strain relief collar (4) onto the torch lead until the gas fitting (3) is tight, or the gas
connection may leak.
3. I n stall the strain relief (1) and secure with nut (2).
4. Connect and tighten the gas fitting (3).
5. Tighten the strain relief collar (4) onto the lead.
3
5
6
2
7
1
3
5
6
4
7
Caution: These are high current connections. Proper
torque is critical.
6. Connect the electrical connections (5), (6) and (7). Tighten
the terminal block screws to 12 kg cm (10 in.-lb).