Hypertherm THC2 Torch Height Control - Manual (Page 10)

Page 1-2 THC-2 Torch Height Control
INSTALLATION - To Cutting Machine & Torch Lifter
FRONT
Figure 1-1 THC-2 Control Module Mounting Dimensions
17-3/32"
15-5/8"
6-3/4"
8"
5/8"
8-32
Tapped
Hole (3)
Bottom
View
INSTALL THE THC-2 CONTROL MODULE
Before installing the THC-2 system, verify the following components after unpacking:
• Voltage Divider
• THC-2 Control Module
• Interconnecting cable #023264 (Cable not available for PAC-500 systems)
Mount the THC-2 Control Module
1. Mount the THC-2 Control Module in a convenient location for the operator. See Fig.1-1
for mounting dimensions. Note the length of the control cable (5 feet) that will connect
from the THC-2 to the inside of the MAX100, MAX100
D
, or MAX200 and make certain
that the cable will reach before mounting. Customers must supply and fabricate cables
for the PAC-500 systems.