Hypertherm THC2 Torch Height Control - Manual (Page 23)

Page 1c-2 THC-2 Torch Height Control
INSTALLATION - PAC-500
MOUNT THE VOLTAGE DIVIDER TO PAC-500
Be sure to complete all steps in Section 1: Installation - To Cutting Machine & Torch Lifter -
in addition to the following procedure for hooking the THC-2 to the PAC-500.
Figure 1c-1 PAC-500 Plasma Control Console Plumbing Compartment
Approximate location
of Voltage Divider
34
1. Open the left door of the PAC-500 plasma control console (plumbing compartment) and
place the voltage divider on the floor of the console - Fig. 1c-1.
2. Attach the white wire from the voltage divider to terminal 34 located on the cathode block
- Fig. 1c-1.
WARNING!
The line disconnect switch for the PAC-500 must be in the OFF position
before proceeding with the installation of the voltage divider and interconnect
cable.