IBASE MI946 - Manual (Page 32)

BIOS SETUP
28 MI946F User’s Manual
BIOS SETUP UTILITY
Main
Advanced
PCIPnP Boot Security Chipset Exit
IDE Configuration
Options:
Disabled
Compatible
Enhanced
<- Select Screen
↑↓ Select Item
+- Change Field
Tab
Select Field
F1 General Help
F10 Save and Exit
ESC Exit
Mirrored IDER Configuration [Enabled]
SATA#1 Configuration [Compatible]
Configure SATA#1 as [IDE]
SATA#2 Configuration [Enhanced]
► Primary IDE Master : [Not Detected]
► Primary Slave Master : [Not Detected]
► Secondary IDE Master : [Not Detected]
► Secondary IDE Slave : [Not Detected]
► Third IDE Master : [Not Detected]
► Fourth IDE Master : [Not Detected]
► Primary IDE Master : [Not Detected]
► Fifth IDE Master : [Not Detected]
► Fifth IDE Slave : [Not Detected]
► Sixth IDE Master : [Not Detected]
► Sixth IDE Slave : [Not Detected]
► 7th IDE Master : [Not Detected]
► 7th IDE Slave
IDE Detect Time Out (Sec)
ATA(PI) 80Pin Cable Detection
: [Not Detected]
[35]
[Host & Device]
The IDE Configuration menu is used to change and/or set the
configuration of the IDE devices installed in the system.
SATA#1 can be configured as IDE, Raid or AHCI Only With MI946RF.
BIOS SETUP UTILITY
Main Advanced PCIPnP Boot Security Chipset Exit
Configure Win627DHG Super IO Chipset
<- Select Screen
↑↓ Select Item
+- Change Field
Tab
Select Field
F1 General Help
F10 Save and Exit
ESC Exit
Serial Port1 Address [3F8/IRQ4]
Serial Port2 Address [2F8/IRQ3]
Serial Port3 Address [Disabled]
Serial Port4 Address [Disabled]
Restore on AC Power Loss [Power Off]
Power On Function [None]