ILS ILS22G winXP - Manual (Page 24)

22
If attached to an intelligent controller, and ILStranslator is functioning as a user interface, you can specify which buttons
are active, which commands to send and where to send them to.
The next item to configure is Projector control via an attached intelligent controller, this also applies to:
• Room light control (Lights)
• Mute Mic control (Mute Mic)
• Mic Volume control (Mic sensitivity)
• Master Volume control (PC Audio)
• Switch control (Source out)
If all of these functions you specify are to be done without interaction with ILStranslator, or ILStranslator as user interface,
choose the second option which directs commands to be performed or controlled ‘externally’. In that case, ILStranslator
will not backlight these buttons.
In the String command text boxes you can define which ASCII
text string is send to the attached
controller. The controller will receive these commands and
translate them into action for the projector connected to the
controller.
In this example the intelligent controller will, after pressing the
Power on button on the ILS22
glass-plate, receive the string ‘C3’, without the quotes as
indication to power on the projector.
The controller will translate that into the correct command and
perform the task of powering on.
In this example the check box for the Projector header is unchecked, so no action will be taken
after pressing the projector header on the ILS22 glass-plate.