Ivoclar Vivadent SR Chromasit - Manual (Page 17)

17
Apply a thin coat of opaquer (wash).
Apply the second opaquer layer, covering the entire metal surface.
Completely opaqued surface.
Leave the opaquer to dry for a few seconds.
Applying the opaquer
Mix SR Chromasit Opaquer with SR Chromasit Opaquer
Liquid to a thick-flowing mixture, using a brush. Cover the
mixture and leave it to swell for approximately 2 minutes.
Then, apply the first coat of opaquer without masking the
framework completely (wash). Make sure to apply opaquer
to all retention areas.
After that, apply another layer of opaquer. This time, the
metal surface should be entirely covered with opaquer. If
necessary, thin the consistency of the opaquer by adding
SR Chromasit Opaquer Liquid.
Mix the opaquer to a thick-flowing mixture, cover
the mixture and leave it to swell for 2 minutes.
To ensure a smooth transition between the metal and
veneering resin, let the opaquer thin out at the metal
margins.
If a smooth surface is required, the opaquer can be
smoothed by applying a vibrating motion for a short time.
Check all critical areas for thorough polymerization, using a
probe.