Ivoclar Vivadent VP3 easy - Manual (Page 8)

8
4.1 Unpacking and checking the contents
Remove the pump from its packaging and check it for any
transportation damage. We recommend keeping the
original packaging for any transportation purposes. Use
only the original packaging for shipping.
Do not carry the pump by holding it by the
connection hose (10), condenser (14), or sound
absorber (4). Support the bottom of the pump
with both hands when carrying it.
4.2 Selecting the location
Place the pump on a flat surface using the rubber feet (1).
Make sure the pump is not exposed to direct sunlight. Do
not place the pump in the immediate vicinity of heaters or
other sources of heat. Make sure that there is enough
space for air circulation between the wall and the air vents
(8).
4.3 Making the connections
Checking the rating plate and power supply
Make sure that the voltage indicated on the rating plate
(6) complies with the local power supply. Should this not
be the case, do not connect the pump.
Connecting the vacuum hose
Remove protective cap (5) from the vacuum hose
connection (7) and slip vacuum hose on the vacuum hose
connection (7). Connect the other end of the vacuum
hose with the furnace.
Please check if the hose is properly connected.
Connecting the power
Plug power plug of the power cord (3) into the
corresponding socket in the Programat. This is the power
supply at the same time.
The electrical installation in the room where the
pump is used must comply with the local and IEC
requirements.
4.4 Mounting the sound absorber
The sound absorber must be mounted prior to setting the
VP3 easy Vacuum Pump in operation. Mount the sound
absorber (4) at the sound absorber connection (2) (see
picture below).
The sound absorber is supplied dismounted to
avoid damage during transportation.
Sound absorber for the Vacuum Pump VP3 easy
– Sound absorber Type B (small) 551 718
.
4. Installation
2 4
Type B
VP easy-BA-WE1.qxd 5.10.2005 11:29 Uhr Seite 8