Datalogic Scanning C-BOX 300 - Manual (Page 24)

C-BOX 300/310
2
2.5 PROFIBUS CONNECTIONS AND SETUP
2.5.1 Profibus Node Address Selection
To interface the C-BOX 3X0 with a Profibus network, the Node Address should be
set using the rotary switches placed in the cover inside.
The valid address range is from 000 to 126.
If an invalid value is detected, the C-BOX cannot communicate with the Profibus
network.
The Node Address can also be assigned through WinHost. Refer to Help on-Line.
Figure 11 - Rotary Switches
2.5.2 Profibus Connector (9-Pin Female External Connector)
To connect C-BOX 3X0 as a Profibus DP Slave, use a standard Siemens Profibus
cable with a 9-pin male connector (see DIN 19245 part 1) and plug it into the 9-pin
female external connector.
5 1
9 6
HUNDREDS TENS UNITS
12