Kemppi DC 3500W - Manual (Page 16)

16 / 1916110E / 9901
English
SAVING MEM. PANEL
SAVING MEM. PANEL
SAVING MEM. PANEL
kuvat 38 - 48
key goes on. You can select the spot time that you
want with the current knob. The time selected is shown
in the numerical display during the adjustment. Five
seconds after the adjustment, the display returns to
the set value of the current and you can adjust the
welding current.
The time shown in the display means the time you have
the welding current. The down-slope and the up-slope
times are increasing the burning time of the arc.
3.5 Memory functions (only with the pulse
panel)
By means of the memory functions you can save 9
panel settings in the permanent memory. All adjusta-
ble or chooseen values are saved in the memory. When
the memory function is not in use, the numerical dis-
play of the memory section is black.
With the CHANNEL key you can select the channel to
be read and used for the saving of a setting.
The MEM / PANEL key is used to select whether to
use the values in the memory or values controlled from
the panel.
The function of the SAVE key is two-phased. When
you press it once, you select the values to be saved. In
this case the light SAVING is blinking to show that you
are performing a saving operation. When the light is
blinking, you can find the channel into which you want
to save the values. When you press the key again, the
information is saved in the memory.
Calling the values from the memory.
1. Press the CHANNEL key so many times that the
numerical channel display shows the number of
the channel that you want. At the same time, the
signal lights of the panel show you the selections
of the selected channel and the current display
shows you the set value of the current. You can
see the other values of the welding parameters by
pressing the parameter key or by turning the po-
tentiometer. All the values are locked, which means
that you cannot change them while the MEM sig-
nal light is on.
2. If you want to change the values found, press the
MEM / PANEL key and the PANEL signal light
comes on and you can change the values.
Saving a welding situation (parameters) in the
memory.
You have good welding values, which you want to save
in the memory.
1. Press the SAVE key once and the SAVING light
starts to blink.
2. Press the CHANNEL key so many times that the
number of the channel in which you want to save
the values is shown in the numerical display.
3. Now press the SAVE key again and the values are
saved in the memory.
Note! When you are saving (= the SAVING light is blink-
ing) and you have rolled the number of the channel
that you want by using the CHANNEL key, you can see
the previous values of that channel by pressing the
MEM / PANEL key to bring the panel to the MEM sta-
tus, so that you can check the present values of that
channel. In this case the values to be saved will not
change. After the check, press the MEM / PANEL key
again and you can again see the values to be saved
and you can save them by pressing SAVE.
3.6 Code locking
The welding machine has a theft protection. You can
install a three-digit machine-specific code into the ma-
chine, which the user must know in order to turn the
machine on. The code is saved in the panel. If you
change the panel the code is follows the panel.
When the machine leaves the factory, the code lock-
ing operation is not on.
Installing the code locking
1. Press the pre-gas key (CODE LOCK) and the key
of the remote control (REMOTE / CODE LOCK/
ENTER) at the same time.
2. Select the first digit from the current adjustment
knob (e.g. 4).
3. Press the accept key (REMOTE / CODE LOCK/
ENTER).
SAVING MEM. PANEL
SAVING MEM. PANEL