Kleenmaid KFL1506 12 programs - Manual (Page 6)

8
The attachment and the inlet hose for
hot water are marked with red colour.
Insert the enclosed washers with the
filter into the loose ends of the hoses
and connect the red marked hose to hot
water tap and the other hose to cold
water tap.
IMPORTANT
The highest allowed temperature of hot
water is 60°C. If your water supply is
hotter than the required temperature,
you must fit a tempering valve,
available from plumbing supply outlets.
High water temperatures may damage
the inlet hoses and valves, which is not
covered by warranty.
Water Outlet
Hook the outlet hose securely over the
edge of the washbasin or tub. The
outlet hose can also be connected
directly to a standpipe, the diameter of
which should be not less than 4 cm.
Wall siphon drain must be correctly
fitted in such manner to enable
cleaning.
If the water is drained through a small
washbasin, always check it is drained
quickly enough, otherwise an overflow
may occur or the machine may pump
the water back. To secure the outlet
hose to prevent movement, tie a string
through the hole on the plastic elbow.
The end of the outlet hose should be
raised from the floor by not more
than 100 cm and not less than 60 cm. If
the hose is positioned higher than
recommended, the machine will not
pump out the water and if lower, it may
syphon the water out.
Connection to Power
Supply
Connect the appliance to the power
supply with the cord provided.
A three pin, switched, earthed power
point less than 1500 mm from the back
of the machine is required. Rated
voltage, frequency and other data are
listed on the rating plate on the back of
the machine. Check that the supplied
electrical voltage is the same as on the
rating sticker.
Your washing machine should be
earthed and connected to the power
supply according to local electricity
supplier regulations and standards.
If the supply cord of this appliance
is damaged, it must be replaced
by the special cord, part no. G
360440, available from your
nearest spare parts centre (refer
to guarantee and service guide).