La Crosse Technology WS-2510 - Manual (Page 22)

22
3.4. Programming mode (entering alarm values)
You can program the weather station so that an audible-visible alarm occurs when certain minimum or maximum values
are reached. As well as this, daily wake-up times can be programmed so that the weather station can also be used as an
alarm clock or an appointment reminder.
Alarm values can be set for:
-High or low temperature for all sensors
- High or low humidity for all sensors with humidity
- High and low air pressure
- High wind speed
- Daily wake-up time
- Separate wake-up time for each day of the week
3.4.1. Programming the min/max alarm values
-
The programming mode is selected by touching field 29 (“ALARM VALUES”).
The display shown below is an example of how the screen appears for the MAX alarm values and the daily wake-up
time. If no alarm value has been set, dashes appear in place of the value display. Wake-up times are only shown in
the MAX display.
- To access the display for the MIN alarm values, the “MIN” touch screen field must be pressed:
-
To return to the display for the MAX alarm values, the “MAX” touch screen field must be pressed:
- The individual outdoor sensors can be selected using touch screen fields 4 or 5 as in the normal display mode.
- Programming mode can either be exited immediately by pressing the “END” key (field 28), or automatically 2 minutes
after the last key has been pressed. In either case, the unit will revert to normal mode.
- To delete the alarm values, the “RESET ” field (field 26) must be pressed for approx. 3 seconds.