D-Link DES-3225G - Manual (Page 51)

24-port NWay Ethernet Switch User’s Guide
Using the Console Interface 41
Figure 6-14. Slot1-Port Configuration screen
♦ Port Field specifies either S1P1, the Port 1x port or S1P2, the Port 2x port on the module. For single-port
modules, only S1P1 will be available.
♦ State Enables or disables this port.
♦ Speed/Duplex Selects the desired Speed and Duplex fort the port. Possible settings include: Auto, 100M/Full,
100M/Half , 10M/Full, or 10M/Half. Choosing Auto enables NWay auto-configuration on the port.
♦ Flow Control Enables or disables IEEE 802.1x full-duplex (only) flow control on this port. See Flow Control in
the Configure Ports section above for a more detailed explanation.
♦ Priority Selects Normal, High or Low. See Priority in the Configure Ports section above for a more detailed
explanation.
♦ Port Lock When locked, automatic learning for all stations connected to this port will stop and entries in the
Forwarding Table for all devices residing on this port will age out. The only traffic this port will allow is traffic from
machines whose MAC address is manually entered in the Static Forwarding Table.
♦ Broadcast Storm Rising Action Selects an action – Do Nothing, Blocking, Blocking-Trap – for the port
when the Broadcast Storm Rising Threshold (below) condition is met. See Broadcast Storm Rising Action in the
Configure Ports section of this manual for a more detailed explanation.
♦ Broadcast Storm Rising Threshold This setting defines a ceiling for the number of broadcast packets per
second on this port. See Broadcast Storm Rising Threshold in the Configure Ports section of this manual for a
more detailed explanation.