Canon XLH1 - Manual (Page 106)

106
Changing the Remote Sensor Mode
Two remote sensor modes and an off setting are available to prevent interference from other Canon
wireless controllers being used nearby.
Turning the Remote Sensor Off
Open the menu and select [SYSTEM/ ]. Select [WL.REMOTE], set it to [OFF ] and
close the menu.
“ ” appears.
Changing the Remote Sensor Mode
1. On the camcorder, open the menu and select [SYSTEM/ ]. Select [WL.REMOTE], set
it to [ 2] and close the menu.
The selected mode appears for a few seconds.
2. On the wireless controller, press and hold the REMOTE SET button. Press the ZOOM
T button for mode 2. Keep the button pressed for over 2 seconds.
If you have set the camcorder to mode 1, press the ZOOM
W button for mode 1.
 The wireless controller returns to mode 1 when you replace the batteries. Change the mode if
necessary.
 Make sure that the camcorder and wireless controller are set to the same mode. Display the
camcorder’s mode by pressing any button on the wireless controller (except the REMOTE SET
button) and set the wireless controller’s mode to the same mode. Change the batteries if the
wireless controller still does not work.
MENU
( 29)
SYSTEM / WL.REMOTE•••• 1
MENU
( 29)
SYSTEM / WL.REMOTE•••• 1