Nuvo ESSENTIA NV-E6GXS - Manual (Page 17)

SYSTEM ZONE TRIGGER OUTPUTS EMITTER OUTPUTS
SYS ON
EXT. MUTE
SUM1 1 3 5 7
8
1 3 5
2 4 6 SUM2 2 4 6
6
d ISC
COMPACT
13
VII. Connecting the IR Emitters for Third-Party Source
Components (Fig. 6)
IR commands for the source equipment are transferred from
the Grand Concerto amplifier to the source equipment using
the mini IR mouse emitters. Six of these are supplied with
the Grand Concerto System. The emitter is plugged into the
corresponding source IR output on the Grand Concerto and
then placed over the IR receiver window on the source
component. The IR outputs are individually routed to
sources 1-6.
NuVo T2G Tuner Direct Numeric Access (Fig. 7)
The NuVo T2G Tuners have the ability for direct IR access to
numeric station tuning. This can be done through the T2G
remote control or using a third party remote control that has
been taught the T2G IR codes. To allow this control, it is
necessary to link one of the Grand Concerto SUM IR outputs
to the Direct IR input on the T2G using a stereo 3.5mm
(1/8”) mono patch cable. Once the connection is made, the
T2G will respond to the numeric IR commands issued
through the Grand Concerto Control Pad IR receivers.
Fig. 6
Fig. 7
NuVoDock for iPod
Note that although the NuVoDock system has a 16 position
rotary switch for source input, only positions 1-6 are used.
Both the wired and wireless NuVoDocks for iPod use a simple
rotary switch to set the appropriate source input. Up to two
wireless NuVoDocks and 6 wired NuVoDocks can be used as
individual sources through NuVoNet. The wired and wireless
NuVoDocks consist of the dock for iPod playback and
recharging and a receiver component designed to
communicate with NuVoNet. Prior to plugging the receiver
into the Grand Concerto EZ Port, set the Source rotary switch
to the desired source number input. Once set, the Grand
Concerto Control Pads will automatically display the iPod
information when an iPod is plugged into the NuVoDock.
Each NuVoDock and receiver must have a separate source
number selected.
3033118
IN TERTEK
CM
Model NV-T2SIR
Dual SIRIUS Ready AM/FM Tuner
www.nuvotechnologies.com
NuVo Technologies LLC Hebron, KY USA •
CONFORMS TO UL STD.60065 CERTIFIED TO CAN/CSA STD.
C22.2 No.60065:06
RS 232
SYSTEM
NuVoNet IR INPUT
RoHS
SYSTEM ZONE TRIGGER OUTPUTS EMITTER OUTPUTS
SYS ON
EXT. MUTE
SUM1 1 3 5 7
8
1 3 5
2 4 6 SUM2 2 4 6
6
T2 Tuner IR Input
Grand Concerto IR Ouput
Music Port MPS4 and MPS4-E
The Music Port and Music Port Elite source components use
the IP connection to the home’s network router for the
source address selection. The Music Port Remote Config
utility is accessed through an internet browser by entering
the Music Port’s IP address followed by /config, ie.
192.168.1.189/config. The Remote Config will open and a
“Source Address” tab allows you to set the source number
for each of the four Music Port audio outputs. These
selections are saved to the Music Port’s flash memory and
when its NuVoNet output is connected to the EZ Port, the
attached Grand Concerto System will recognize the Music
Port sources. The SUM1 and SUM2 outputs will flash any IR command that
is sent from any of the zones. This is most commonly used
with an IR blaster designed to flash IR commands to a variety
of components.