Leprecon Watson User Manual
Page 6
6
3) Installation
Mounting
Each Watson system ships with a simple metal bracket that will accept a standard C
clamp. The packaging for the bracket includes the screws that are needed to attach the
bracket to the Watson chassis.
Power Connection
For full current operation, 12 gauge power cords are recommended to power Watson
and the fixtures downstream. Leprecon can supply NEMA 5-15 to Powercon cables in
several lengths.
Load Connection
Fixtures or other devices connected to the output of Watson can be turned off remotely.
The powered devices are protected by an internal circuit breaker on the Watson unit. To
prevent overload, make sure that the total wattage of devices connected to Watson is
less than 15 amps.
4) Turning on Power
Watson has one line cord and circuit breaker. When power is applied, and the breaker is
turned on, the breaker will be illuminated by a green pilot lamp. When first powered, the
red display on the Watson front panel will light.
Note:
Watson is designed to turn off the display after a short delay with no activity. Even if the
display is not lighted, Watson is still operational.