Leprecon Watson - Manual (Page 9)

9
Mode Menu
The Mode Menu sets the way Watson performs power switching.
Press the Menu button once to enter set the operating mode:
The display shows C1, then the selected mode.
Set the mode for the displayed address by pressing the UP/DOWN buttons. The
possible modes are:
Mode Description
Nd Non- dim. DMX level above 60% turns on the output. When the DMX
level is below 40% the output is off
Au Output switched on whenever DMX is present.
Of Output permanently off (test mode)
On Output permanently on (test mode)
After changing the mode the colon will blink to indicate new data has been entered.
Pressing the ENTER key saves the change.
Watson returns to the main display automatically after 4 seconds if no keys are pressed
in the Mode Menu.
C1:nd