Leprecon ULD-360DMX - Manual (Page 13)

- 13 -
Once the input levels for all dimmer channels have been shown, the display will then
indicate the output level for each channel. This is indicated by the letter ‘o’ in the
display, followed by channel number, followed by output level. Output will be shown as a
percentage, with 100% indicated b the letters ‘FF’
Pressing the ENTER, UP or DOWN keys stops the auto cycle mode and enters manual
mode. Pressing MENU toggles between auto and manual cycle modes.
In manual mode the menu steps through its displays when the UP or DOWN keys are
pressed. The colon is steady in manual mode.
If a channel has been set to a fixed level in the Channel menu, the output status will
reflect that level. In this case, the input for channel 1 could be zero, but there could be a
non-zero output level.
Status Letter Description
– No input detected
d DMX is input source
o Output level
F Output Fault – Overtemp or Overvoltage shutdown
Note:
The unit can be Reset to original factory settings by depressing and holding the
ENTER switch while turning on the first breaker.
d1:00
o1:FF