Leprecon ULD-360DMX - Manual (Page 5)

- 5 -
Control input
The ULD-360 DMX accepts DMX 512 1990 as specified by USITT. Reliable DMX
systems require cable rated for data communication at 250K baud; for this reason the
use of microphone cable is NOT recommended. DMX rated cables are available pre-
manufactured from your Leprecon dealer. For more information on the DMX standard
and acceptable cable, see the Appendix at the end of this manual.
For convenience, DMX in and out connectors are provided on the ULD-360DMX. This
allows easy connection to additional dimmer packs. The DMX standard allows up to 32
dimmers to be connected to a single DMX controller.
For proper operation, it is recommended that the last dimmer in the system have a
termination plug placed in the DMX Out connector. Termination plugs can be
purchased, or easily built by installing a 120-ohm resistor between pins 2 and 3 of the 5
pin XLR.