Q-See Computer Hardware - Manual (Page 83)

SuperDVR & H.264 Series Cards
User Manual
Error! Use the Home tab to apply
标题 1 to the text that you want to
appear here. Error! Use the Home
tab to apply
标题 1 to the text that
you want to appear here.
83
Set P.T.Z device Baud rate, default value is 9600, used value must match
Baud rate on PTZ control board
C.Data bits
Default value is 8, used value much match Baud rate on PTZ control board.
D.Parity
Odd and even parity bit, default Null, used value must match Baud rate on
PTZ control board
E.Stop bits
Default value is 1, used value must match Baud rate on PTZ control board
Notice: Users should look into the P.T.Z device and get Baud rate,
Protocol and Address first, and then set other values accordingly.
By clicking , users can copy the setting of this channel to any other
selected channel.
7.6 Mobile Surveillance
7.6.1 Introduction to Mobile Surveillance
This DVR supports mobile surveillance by smart phones and PDAs with Win
Mobile Pro or Symbian operating systems that are on 3G networks. Among
these, Dopod D600 (WM5) and Dopod S1(WM6) have been tested and fully
certified that they worked well with the DVR.
You need to setup the network configuration on the DVR before you can
access mobile surveillance (Please see Chapter 7.1 Remote Live
Surveillance). The following are the instructions for the two operating
systems.
Notice : Mobile devices can only access one channel at a time.
7.7 By Smart Phone with Win Mobile Pro or Classic
Operating System
Please use smart phones or PDAs with WinCE version supported by this unit.
STEP1
： First, activate the network access on the mobile phone, and then
run “Internet Explorer”.
STEP2
： Input the public IP address you need to use to connect as shown
below: