Switching the display’s brightness, Stopping digital outputs, Using the sleep timer – Marantz NA8005 User Manual
Page 33: V p. 33), This sets the sleep timer. (v p. 33)
Switching the display’s brightness
The display brightness can be adjusted between four levels. Switching the
display off reduces a source of noise that affects sound quality, enabling
higher sound quality playback.
1
Press DIMMER.
0 When the display is turned off, the DISPLAY OFF indicator lights.
0 If you operate the buttons when the display brightness is set to “Off”, the display
temporarily lights at 100% brightness level.
Stopping digital outputs
Stopping digital audio output reduces a source of noise that affects sound
quality, enabling higher sound quality playback.
1
Press DIG. OUT.
The digital audio output is switched on and off each time the button
is pressed.
0
When digital output is turned off, the “DIG. OUT OFF” indicator
lights up on the display.
Using the sleep timer
Use this function to automatically switch the power to the standby mode
after a specific amount of time (minutes).
1
Press SLEEP during playback and select the setting
time.
0
The sleep timer can be set to up to 90 minutes, in steps of 10
minutes.
0
After about 3 seconds, the setting is entered and the display
returns to as it was before.
o
Canceling the sleep timer
Either press SLEEP to select “Sleep 1 OFF” or press POWER X.
o
To check the time remaining until the sleep
timer is activated
Press SLEEP.
33