Operation, Connecting the power supply, Normal playback 7 super audio cd player playback – Marantz SA-11S1 User Manual

Page 17

Advertising
background image

ENGLISH

12

OPERATION

* In this instruction manual, some operations can only be performed with the remote control. For operations that can be

performed with buttons both on the main unit and on the remote control, the button names are shown in the

mark.

And for operations that can only be performed with buttons on the remote control, the button names are shown in the
mark.

CONNECTING THE POWER SUPPLY

1

Plug the power cable into AC IN jack on the back panel.

2

Turn on the power switch of the audio unit (amplifier, etc.)
that is connected with this unit. Set the selector on the
connected unit to this unit.

3

Plug the power cable into an AC outlet.

NORMAL PLAYBACK

7 Super Audio CD player playback

PAUSE

STOP

PLAY

OPEN/

SOUND

POWER ON/OFF

SUPER AUDIO CD PLAYER SA-11S1

CLOSE

MODE

DISPLAY OFF

q Press POWER switch to turn on.

LCD

The display cycles from TOC Reading

→ No Disc (when

no disc is loaded)

→ Super Audio CD (when the start sound

mode setting is Super Audio CD).

w Press the

OPEN/CLOSE

button

The disc tray comes out. Place the disc with label side up
on the tray.
To play a single (8cm) CD, place the disc with the
indentation at the center of the tray.

e Press

OPEN/CLOSE

button.

r Press

PLAY

button.

Disc type is automatically detected and playback is started.
Track number and track elapsed time(minute, second)
appear on the display.

* For Super Audio CD/CD hybrid-layer discs (See page 3),

the layer that is set in the start sound mode (See page
13) is played. To change the layer, use the

SOUND MODE

button. (See page 13)

(Exp.:Track 6, Elapsed time 2 min 8 sec)

Playback automatically stops at the end of the final track.

Number of current track

Minutes

Seconds

Remaining track numbers

AC IN

Advertising
This manual is related to the following products: