Initial set up to turn off the power – Marantz VP-12S1N User Manual
Connect the supplied AC power cord.
The STANDBY indicator lights up and the projector
goes into the standby mode.
Press the POWER ON key on the remote controller or
the POWER key on the projector.
The POWER indicator lights up.
Press the FOCUS key on the remote controller to
display the FOCUS pattern and turn the Focus ring to
make an adjustment. Adjust the focus for the sharpest
image possible to obtain, using focus pattern.
Press the FOCUS key again to clear off the pattern.
Turn the Zoom ring to adjust the size of the image.
Switch on the equipment connected to the projector.
Press the INPUT SELECT key on the projector or the
COMPONENT key, S-VIDEO key, VIDEO key, or RGB
key on the remote controller.
Press the STANDBY key on the remote controller or the
POWER key on the projector.
The fan continues to run for a while to reduce internal
heat. The POWER ON indicator flashes in blue and no
key will be active minute. After about one minute
cooling has been provided, the unit turned off and the
STANDBY indicator lights up.
INITIAL SET UP
TO TURN OFF THE POWER