Marantz VP-12S1N - Manual (Page 3)

1
ENGLISH
FOREWORD
This section must be read carefully before any connection
is made to the mains supply.
WARNINGS
EQUIPMENT MAINS WORKING SETTING
Your Marantz product has been prepared to comply with the
household power and safety requirements that exist in your
area.
IMPORTANT: (FOR UK version only)
This apparatus is fitted with an approved moulded 13
Ampere plug. To change a fuse in this type of plug proceed
as follows:
1. Remove fuse cover and fuse.
2. Fix new fuse which should be a BS1362 5A, A.S.T.A.
or BSI approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it
should be cut off and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value
of 5A. If a plug without a fuse is used, the fuse at the
distribution board should not be greater than 5A.
Note :
The severed plug must be destroyed to avoid a possible
shock hazard should it be inserted into a 13A socket
elsewhere.
HOW TO CONNECT A PLUG
The wires in the mains lead are colored in accordance with
the following code:
BLUE—“NEUTRAL” (“N”)
BROWN—“LIVE” (“L”)
GREEN-and-YELLOW —”EARTH” (“E”)
1. The BLUE wire must be connected to the terminal
which is marked with the letter “N” or colored BLACK.
2. The BROWN wire must be connected to the terminal
which is marked with the letter “L” or colored RED.
3. Do not connect either wires to the earth terminal in the
plug which is marked by the letter “E” or by the safety
earth symbol
or colored green or GREEN-and-
YELLOW.
Before replacing the plug cover, make certain that the
cord grip is clamped over the sheath of the lead — not
simply over the two wires.
Copyright
Recording and playback of some material may require
permission. For further information refer to the following:
- Copyright Act 1956
- Dramatic and Musical Performers Act 1958
- Performers Protection Acts 1963 and 1972
- Any subsequent statutory enactments and orders
Do not expose the equipment to rain or moisture.
Do not remove the cover from the equipment.
Do not push anything inside the equipment through
the ventilation holes.
Do not handle the mains lead with wet hands.
WARNINGS
• When the projector is mounted on the ceiling, the Ceiling
Mount Kit approved by MARANTZ must be used for
installation.
• Do not look into the lens when the projector is turned on. It
could damage your eyesight.
• Unplug the projector from the wall outlet if it is not to be used
for a few days.
• When the switch is in the OFF position, the apparatus is NOT
disconnected from the AC supply mains.
• The socket-outlet shall be installed near the equipment and
shall be easily accessible.