Montigo B34DV - Manual (Page 3)

Page 3
B-Series DV-2 Gas Fireplace
Part No. XG0160 - 141231
Introduction
Thank You for choosing a Montigo Gas Fireplace.
About this Fireplace:
The B-Series DV-2 is a dual burner fireplace with glowing embers.
The fireplace is available in three models, and in top or rear vent for
each model.
Standard Log Set
The B34DV-2 is rated for Natural Gas at 18,000 BTU/H (5.28
Kilowatts) Input or Propane at 18,000 BTU/H (5.28 Kilowatts) Input.
■ B34DT-2; Top Vent, Millivolt Pilot.
■ B34DR-2; Rear Vent, Millivolt Pilot.
■ B34DT-2-I; Top Vent, Intermittent Pilot (HSI).
■ B34DR-2-I; Top Vent, Intermittent Pilot (HSI).
■ B34DT-2-F; Top Vent, Electronic Ignition (IPI).
■ B34DR-2-F; Top Vent, Electronic Ignition (IPI).
Standard Log Set
The B38DV-2 is rated for Natural Gas at 21,000 BTU/H (6.16
Kilowatts) Input or Propane at 21,000 BTU/H (6.16 Kilowatts) Input.
■ B38DT-2; Top Vent, Millivolt Pilot.
■ B38DR-2; Rear Vent, Millivolt Pilot.
■ B38DT-2-I; Top Vent, Intermittent Pilot (HSI).
■ B38DR-2-I; Top Vent, Intermittent Pilot (HSI).
■ B38DT-2-F; Top Vent, Electronic Ignition (IPI).
■ B38DR-2-F; Top Vent, Electronic Ignition (IPI).
How to use this manual:
This manual covers installation, operation and maintenance. Lighting,
operation and care of this fireplace can be easily performed by the
homeowner. However, all installation and service work should be
performed by a qualified or licensed installer, plumber, or gasfitter who
is qualified or licensed by the state, province, region, or governing body
in which the appliance is being installed.
This manual covers all models and unless otherwise specified, the
designation B-Series DV-2 refers to all models. Sections which are
specific to a particular model are marked with a symbol, plus
the appropriate model number.
Warranty and Installation Information:
The Montigo warranty will be VOIDED by, and Montigo disclaims any
responsibility for, the following actions:
■ Modification of the fireplace and/or components including Direct-Vent
assembly or glass doors.
■ Use of any component part not manufactured or approved by Montigo in
combination with this Montigo fireplace system.
■ Installation other than as instructed in this manual.
Consult your local Gas Inspection Branch on installation requirements
for factory-built gas fireplaces. Installation & repairs should be done by
a qualified contractor.
Installations in Canada must conform to the current CAN/CGA B-149.1
and .2 Gas Installation Code and local regulations. If the optional air-
circulating fan kit is installed, it must be electrically grounded in accordance
with CSA C22.1 Canadian Electrical Code Part 1 and/or Local Codes.
Installations in the USA must conform to local codes, or in the absence
of local codes to the National Fuel Gas Code, ANSI Z223.1-1988. If the
optional air-circulating fan is installed, it must be grounded in accordance
with local codes or, in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70-1987. See Appendix B for installation
within the State of Massachusetts.
CAUTION!
Due to its high operating temperatures, the appliance should
be located out of traffic & away from furniture and draperies.
 Children and adults should be alerted to the hazards
of the high surface temperature, which could cause
burns or clothing ignition.
 Young children should be carefully supervised when
they are in the same room as the appliance.
 Clothing or other flammable materials should not be
placed on or near the appliance.
WARNING
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.