Nevion 3GHD-CHO-2x4 - Manual (Page 11)

3GHD-CHO-2x4/2x3 Rev. C
nevion.com | 11
7
Status from Multicon Gyda
7.1 Label and picture
The module label is show above the picture. The picture is changing depending on the status
of the module. All alarms are shown with red crosses. The output selection and the main input
on the change over block are shown by changing the lines inside the switch block.
7.2 Input
Input signal status is show together with the configuration of the inputs; bypass, mute or
normal.
7.3 GPI
Show the status of the input pin on the GPI connector on the backplane. Inactive means no
signal while Active mean signal.
7.4 Voltage
Shows the actual voltages on the module together with the nominal voltages.