Nevion 3GHD-CHO-2x4 - Manual (Page 18)

3GHD-CHO-2x4/2x3 Rev. C
nevion.com | 18
9
Alarms on Multicon Gyda
Each alarm can be set to be ignored by the Multicon Gyda alarm handling. Also SNMP tram
can be configured to send or ignore alarms. Configure the alarms in Multicon Gyda do not
change the behavior of the LED’s on the module.
9.1 Electrical input
If the electrical input is missing this alarm will be raised
9.2 Reclocker
If the reclocker does not lock to the incoming signal an alarm will be raised.
9.3 Change over
If the changeover has switch to the backup channel this alarm will be raised.
9.4 GPI
If an input signal is present on the GPI input, these alarms will be raised.
9.5 Voltage
If the voltages is out of the range, these alarms will be raised.