NIStune Type 3 User Manual
Page 8

Type 3 Hardware Installation Manual
Page 7 of 12
3. Nistune BOARD JUMPER SETTINGS
Solder jumpers on the Nistune board are used to select between different ECU types.
*** J4 “PGM” jumper is only used when programming the base image into the board and must
always be removed before the board is fitted to the ECU or it will not run.
Most users will not need to change these as the board will be set up at the factory. But tuners/dealers
who buy bulk boards and then program the base images themselves will need to solder these jumpers
after programming.
Model
Name
Engine
ECU Series
Jumper
S13
180SX
SR20DE, DET
52Fxx, 50Fxx
J1
S13
240SX
KA24DE
53Fxx, 54Fxx, 59Fxx
J1
W10
Avenir
SR20DET
95Nxx
J1
U12/13
Bluebird
SR20DET
79Exx, 1E0xx, 4E6xx
J1
U13
Bluebird
KA24DE
3E6xx, 1E4xx
J2+J3*
S14
Silvia (early)
SR20DET
69Fxx, 74Fxx, 75Fxx
J2
64Yxx, 67Yxx, 70Yxx, 71Yxx, 78Cxx
J1
B13
Sentra/NX2000
SR20DE
94Yxx
J2 + J3*
N14/15
Pulsar
SR18DE, SR20DE
58Yxx, 68Cxx, 1N960
J1
RNN14
Pulsar GTiR
SR20DET
54Cxx, 69Cxx
J1
Z32
300ZX late
VG30DE(TT)
45Pxx, 51Pxx, 52Pxx, 53PXX
J2
J30
Maxima
VE30DE
97Exx
J1
62Jxx, 70Jxx, 71Cxx, 77Jxx, OJ26x,
OJ27x
J1
P10
Primera
SR20DE
83Jxx
J2 + J3*
* Important: Board must be marked 'CPLD Rev D/GA' to use this setting