Norsat O3b 5W BUC - Manual (Page 11)

Rev. 1.0
7005STC-O3B Series
DES007565
11
4. INSTALLATION
This section of the manual is intended to provide aid in BUC installation.
4.1 UNPACKING
Perform an initial inspection upon receiving the BUC. You are advised to ensure the following:
 Check that the shipping container is not opened or damaged.
Have a representative from the shipping company present if you suspect that the
shipment is damaged or tempered with before opening the container.
 Check that all items in the packing list are present and undamaged.
 If any loss or damage is discovered, contact XMW Inc. or a local representative before
proceeding.
 The shipping container and packing materials should be retained for possible reshipment.
Accessories for 7005STC-O3B-A or 7005STC-O3B-B are four waveguide adapter fixing screws,
an O-ring for the waveguide adapter.
4.2 INSTALLATION ON ANTENNA
7005STC-O3B-A and 7005STC-O3B-B have two M4 threaded holes at each side of BUC as shown
in Fig. 6 and these holes are used to fix the mounting bracket when used as stand-alone unit.
Please fix proper brackets to four fixing holes on the BUC before mounting the BUC to the antenna.
One of these fixing holes can be used to connect the BUC housing to the earth for grounding.
Fixing holes for mounting brackets
Figure 6. Location of fixing holes on Ka 5W BUC