Norsat O3b 5W BUC User Manual

Page 20

Advertising
background image

Rev. 1.0

7005STC-O3B Series

DES007565

20

5.2.4 Ethernet Mode Operation

For Ethernet mode operation, connect a prepared Ethernet cable between the MS 12-pin
connector on the BUC and the PC Ethernet port as shown in Fig. 14 or Fig. 15. Refer to Table 1
and Fig. 4 for Ethernet connection.

Figure 14. Ethernet connection between BUC

and PC


Figure 15. Ethernet connection between BUC and PC via 10M or 10/100M Hub or Switch

Click BUC GUI icon on your PC and a BUC GUI window like Figure 12 shows up. However, unlike

serial mode connection, parameters for BUC and PC should be set up separately. And Ethernet

parameters setup for BUC should be done on your PC in the serial mode. The setup order for

Ethernet connection is as follows:

A. BUC parameters setup for Ethernet connection:

Parameters for BUC are sent to BUC when you enter necessary serial Commands into the serial

command text box and click the SEND tab in the red box of Fig. 13. Eight steps below are required to

set up BUC parameters for Ethernet connection.

Step 1. Set up BUC IP

- Serial command: ipwr 192 168 100 15 (Write Command)

- Serial command: iprd (Read Command)

Advertising