Norsat O3b 20W BUC - Manual (Page 11)

4. INSTALLATION
This section of the manual is intended to provide aid in BUC installation.
4.1 UNPACKING
Perform an initial inspection upon receiving the BUC. You are advised to ensure the following:
 Check that the shipping container is not opened or damaged.
Have a representative from the shipping company present if you suspect that the shipment
is damaged or tempered with before opening the container.
 Check that all items in the packing list are present and undamaged.
 If any loss or damage is discovered, contact NORSAT Inc. or a local representative before
proceeding.
 The shipping container and packing materials should be retained for possible reshipment.
Accessories for 7020STC-O3b A or B are four waveguide adapter fixing screws, and an O-ring for
the waveguide adapter.
4.2 INSTALLATION ON ANTENNA
7020STC-O3b have two M4 threaded holes at each side of BUC as shown in Fig. 6 and these
holes are used to fix the mounting bracket when used as stand-alone unit. Please fix proper
brackets to four fixing holes on the BUC before mounting the BUC to the antenna. One of these
fixing holes can be used to connect the BUC housing to the earth for grounding.
Figure 6. Location of fixing holes on Ka 20W BUC
© 2014 Norsat International Inc. Page 11 of 25