Norsat O3b 20W BUC - Manual (Page 18)

Step 1. Set up BUC IP
- Serial command: ipwr 192 168 100 20 (Write Command)
- Serial command: iprd (Read Command)
Step 2. Set up BUC Port
- Serial command: portwr 4001 (Write Command)
- Serial command: portrd (Read Command)
Step 3. Set up Gateway
- Serial command: gwwr 192 168 100 1 (Write Command)
- Serial command: gwrd (Read Command)
Step 4. Set up Subnet Mask
- Serial command: smwr 255 255 255 0 (Write Command)
- Serial command: smrd (Read Command)
Step 5. Set up Mac address
- Serial command: macwr ff 11 dd 22 12 (as an example) (Write Command)
- Serial command: macrd (Read Command)
Step 6. Set up PC IP
- Serial command: sendipwr 192 168 100 10 (as an example) (Write Command)
- Serial command: sendiprd (Read Command)
In this step, you have to input IP of the computer which you’re using.
Step7. Set up PC Port
- Serial command: sendportwr 4001 (Write Command)
- Serial command: sendportrd (Read Command)
B. PC parameters setup for Ethernet connection:
There are two steps to perform for PC parameters setup for Ethernet connection.
Step 8. Set up PC parameters
The BUC IP, BUC PORT, and PC PORT number should be entered into the Ethernet
parameters
boxes on BUC GUI window as shown in Fig. 10.
© 2014 Norsat International Inc. Page 18 of 25