OWON AG1022 - Manual (Page 29)

5.Front Panel Operation
Figure 5-15 choose the .ota file
(3)
Choose Recall output. And the tip “Read file successfully” will show on the interface.
Figure 5-16 Read file
Tips:
1. Normally the frequency, amplitude, and offset of the recalled wave are the same as the wave being
cut, but when the frequency, amplitude, and offset are set out of the limit range, then the waveform
generator would use the current parameter, which leads to the recalled wave not totally the same as
the cut wave.
2. The max data number of the waveform generator ARB is 8192. When the wave cut from
oscilloscope contains data number more than 8192, the waveform generator will compress data. On
the contrary if the data number is less than 8192, the waveform generator will use linear
interpolation.
To Save and Recall
Press Save function button to enter the file system.
To Use USB Storage
The storage location is divided into the internal storage (FLASH) and the U disk storage
(USBDEVICE). When a U disk is connected, the storage menu will show "USBDEVICE" and
24